StickerFab Fog Light Overlays for Tacoma (2024+)

For those who prefer the look of yellow or amber fog lights, these Fog Light Overlays offer a simple way to change the appearance and color output of your factory fogs. Designed specifically for the 2024+ Toyota Tacoma, they add subtle styling while keeping an OEM-plus look.

Available in multiple material options—including the new Version 2 snap-in acrylic design—these overlays are easy to install and sold as a pair with an extra backup set included.

Note

• Color Output: Deep amber provides the strongest amber appearance but slightly reduces light output.
• Lamp Compatibility: Not compatible with RIGID fog lamps (Pro / Trailhunter) without modification.
• Shared Fitment: Fitment is the same between the 2024+ Tacoma and 2025+ 4Runner and has been verified.

Features

• Easy Installation: Simple install process with minimal tools required.
• Color Change: Converts factory fog light output to yellow or amber tones.
• Subtle Styling: Enhances the front-end appearance without permanent modification.
• Multiple Material Options: Available in vinyl, acrylic, and acrylic V2 snap-in versions.
• Snap-In Acrylic V2: New version clips into place with no adhesive required.
• Direct Fit: Designed specifically for the 2024+ Toyota Tacoma.
• Extra Set Included: Sold as a pair with an additional spare set included.

Vehicle Fitment

• Vehicle: 2024+ Toyota Tacoma

Package Contents

• Fog Light Overlays: 1 pair (plus extra backup set)

Installation Instructions

General Preparation

• Surface Cleaning: Clean the lens using a wax-free detailing spray.
• Temperature: Recommended installation temperature is 70°F or higher.
• Environment: Install in the shade to avoid premature adhesion.

Acrylic (Adhesive Version)

• Clean Lens: Ensure the factory lens is free of dirt and residue.
• Test Fit: Confirm placement before removing adhesive.
• Apply Adhesive: Remove backing from the small side strips only.
• Secure Overlay: Align carefully and press firmly into place.
• Finish: Remove the protective film.

Acrylic V2 (Snap-In Version)

• Clean Lens: Clean factory fog light lens thoroughly.
• Install Tabs: Insert bottom tabs first, then press the top into place.
• Secure Fit: Ensure all four tabs are seated behind the bumper cover.
• Removal: Apply upward pressure on the bumper cover and reverse the installation steps.

Vinyl Installation

• Recommended Tools:
  • Microfiber towel
  • Wax-free detailing spray
  • Soapy water or StickerFab Application Fluid
  • Felt-tip squeegee
  • Heat gun or hair dryer (optional)
• Wet Install: Apply fluid to both the vinyl and lens surface to allow repositioning.
• Positioning: Slide vinyl into place until aligned correctly.
• Squeegee: Gently remove excess water and air bubbles.
• Drying: Allow to dry in sunlight, then recheck edges.
• Heat (Optional): Use light heat on edges only—do not overheat.