For those who prefer the look of yellow or amber fog lights, these Fog Light Overlays offer a simple way to change the appearance and color output of your factory fogs. Designed specifically for the 2024+ Toyota Tacoma, they add subtle styling while keeping an OEM-plus look.
Available in multiple material options—including the new Version 2 snap-in acrylic design—these overlays are easy to install and sold as a pair with an extra backup set included.
Note
Color Output: Deep amber provides the strongest amber appearance but slightly reduces light output.
Lamp Compatibility: Not compatible with RIGID fog lamps (Pro / Trailhunter) without modification.
Shared Fitment: Fitment is the same between the 2024+ Tacoma and 2025+ 4Runner and has been verified.
Features
Easy Installation: Simple install process with minimal tools required.
Color Change: Converts factory fog light output to yellow or amber tones.
Subtle Styling: Enhances the front-end appearance without permanent modification.
Multiple Material Options: Available in vinyl, acrylic, and acrylic V2 snap-in versions.
Snap-In Acrylic V2: New version clips into place with no adhesive required.
Direct Fit: Designed specifically for the 2024+ Toyota Tacoma.
Extra Set Included: Sold as a pair with an additional spare set included.
Vehicle Fitment
Vehicle: 2024+ Toyota Tacoma
Package Contents
Fog Light Overlays: 1 pair (plus extra backup set)
Installation Instructions
General Preparation
Surface Cleaning: Clean the lens using a wax-free detailing spray.
Temperature: Recommended installation temperature is 70°F or higher.
Environment: Install in the shade to avoid premature adhesion.
Acrylic (Adhesive Version)
Clean Lens: Ensure the factory lens is free of dirt and residue.
Test Fit: Confirm placement before removing adhesive.
Apply Adhesive: Remove backing from the small side strips only.
Secure Overlay: Align carefully and press firmly into place.
Finish: Remove the protective film.
Acrylic V2 (Snap-In Version)
Clean Lens: Clean factory fog light lens thoroughly.
Install Tabs: Insert bottom tabs first, then press the top into place.
Secure Fit: Ensure all four tabs are seated behind the bumper cover.
Removal: Apply upward pressure on the bumper cover and reverse the installation steps.
Vinyl Installation
Recommended Tools:
Microfiber towel
Wax-free detailing spray
Soapy water or StickerFab Application Fluid
Felt-tip squeegee
Heat gun or hair dryer (optional)
Wet Install: Apply fluid to both the vinyl and lens surface to allow repositioning.
Positioning: Slide vinyl into place until aligned correctly.
Squeegee: Gently remove excess water and air bubbles.
Drying: Allow to dry in sunlight, then recheck edges.
Heat (Optional): Use light heat on edges only—do not overheat.
