Yota Wolf Carbon Fiber Mirror Covers for Tacoma (2024-2026) / 4Runner (2025-2026)

Swap the plain factory mirror caps for a gloss carbon fiber look that matches the rest of your build. These covers stick on right over your factory caps, so there's nothing to remove, drill or wire, and your turn signals keep working and stay visible.

Fitment

Fits: 2024-2026 Toyota Tacoma and 2025-2026 4Runner with turn signals built into the side mirrors.

Not sure about your trim? Check for a turn signal light along the front edge of your mirror, or message us with your year and trim before you order. We'll confirm fit for you.

Why you'll like them

• Carbon fiber look finish: Gloss carbon twill pattern on durable ABS plastic. Lightweight and fade resistant. (This is a carbon fiber look, not real carbon fiber.)
• Protects your factory caps: Adds a layer over the original caps against everyday scuffs and scratches.
• Turn signal stays clear: Shaped to sit above the factory signal, so nothing is covered.
• No drilling or wiring: Double-sided tape comes pre-applied, plus an extra roll is included.
• Quick install: Takes a few minutes, no tools needed.

What's included

• 2 mirror covers (driver and passenger side)
• 1 extra roll of double-sided tape

Installation

1. Test fit first. Hold each cover in place before peeling the tape. If it doesn't line up, stop and contact us. Don't install it.
2. Clean and dry. Wipe the factory caps with rubbing alcohol and let them dry fully. Install in warm, dry weather for the best bond.
3. Peel and press. Remove the tape backing, line up the cover, then press firmly for at least 2 minutes, especially around the edges.
4. Let it cure. Keep the covers dry and skip the car wash for 72 hours.

Specs

• Material: ABS plastic
• Finish: Gloss carbon fiber pattern
• Mounting: Double-sided adhesive tape (pre-applied)
• Quantity: 1 pair